Summer Starts Here - Save up to 70%
Trailer Wiring Harness Installation - 2013 Mercedes-Benz Sprinter- Video
Today on our 2013 Mercedes-Benz Sprinter we're going to be installing the Tow Ready Upgraded Circuit Protected Modulite with 4 Pole Harness, part number 119179KIT. We're going to begin here by first opening up both of the rear doors of the vehicle. Now we've already gone and determined that the taillights are actually three wire system because the top light here is the brake light, the middle light here is the turn signal and this section right here is actually the running light. We're going to need to remove the light assembly from the vehicle by removing this screw here, here, and there. Go ahead and take our plastic trim panel tool here just work it in behind the light to release the snaps, the clips, that hold it in place. In order to get the light plug out here you're going to need to . there's a little locking tab on the top and bottom. Just take a little flat head screw driver and just kind of push it in as you work the tab outward. more
2/12/2015 2:52:33 PM
Hopkins Endurance Multi-Tow Trailer Connector Installation - 2014 Mercedes-Benz Sprinter- Video
Today on this 2014 Mercedes Benz Sprinter Van, we're going to install part number HM48470 from Hopkins. Now our new connector is going to replace the pre-existing seven pole connector on our van. We'll go and dismantle your existing connector and get down to our bare wires. Once we're down to our bare wires we'll go ahead and even them out. Take our four pole wires and spread them apart. Now our four pole wire we have a white ground wire which really isn't being used, so we're just going to cut it off short because we already have a pre-existing ground wire thats much larger and can carry the current of our remaining wires. Okay, we take our wires and we're going to run them through the cover here first. more
7/29/2014 4:17:51 PM
Trailer Wiring Harness Installation - 2014 Mercedes-Benz Sprinter- Video
Today on this 2014 Mercedes Benz Sprinter van we're going to install part number 119190KIT. One thing to know about our install is that we're going to need access to the battery, so one of our first steps is to go ahead and get our vehicle ready to install our parts. We're going to be in the cab of the van, so we'll go ahead and remove this panel right here and the torque's that we use is a T25. Put our panel to the side in a safe spot. Now go ahead and take the floor mat out of the way. We'll get access to the battery by loosening up these four screws. Slide our panel back and go ahead and remove it. more
7/29/2014 11:34:13 AM
Filter Videos
Filter Videos
